2016-2018 Ford Focus RS Front License Plate Bracket - No Hardware

Are you tired of having your front license plate flop around or even fall off your 2016-2018 Ford Focus RS? Look no further than this Genuine OEM Front License Plate Bracket. This bracket is specifically designed to fit your Focus RS, ensuring a perfect fit and secure hold for your license plate.

Installation Instructions:

To replace the existing front license plate bracket on your 2016-2018 Ford Focus RS with the new bracket, follow the steps below:

1. Gather the necessary tools: a drill, a drill bit appropriate for drilling through metal, a screwdriver, and a wrench.

2. Locate the existing front license plate bracket on your vehicle and remove it by unscrewing the screws or bolts that are holding it in place.

3. Hold the new license plate bracket up to the area where the old bracket was and mark the drill holes using a marker or pen.

4. Using the appropriate drill bit, drill the marked holes in the appropriate locations.

5. Attach the new license plate bracket using the screws or bolts provided with the vehicle or use the ones that you removed from the old bracket.

6. Tighten the screws or bolts securely using a screwdriver and wrench.

Skill level required for this installation is moderate. Some mechanical knowledge and experience is recommended.

The time it takes to complete the job depends on the installer's skill level and experience, but it should take approximately 30-60 minutes to complete the installation.

Note: The installation kit may or may not include hardware (such as nuts, bolts, or screws) necessary for installation. Please refer to the manufacturer's instructions to confirm if any additional hardware is required.